![]() is kept straight and not bowed up or down, shim with balsa if required. IMPORTANT: for a warp free straight wing, make sure T.E. Chipmunk Basic Basic Language Manual and README file (which includes a Quick Reference to Mac OS and other new functions) (Please see below for much more documentation.) Please join the Chipmunk Basic Discussion Forum in Yahoo Tech Groups to ask questions, share information, or even contribute your own Chipmunk Basic programs. (NOTE: slots in rib 2 must be towards upper rib edge, slots in ribs 7&8 must face up towards rear of wing as shown). Working one at a time, glue remaining ribs 2 to 8 & 10 to 15 to spar and T.E. With landing gear slots facing up, set ribs 4 & 5 in position (NOTE: rib 5 ply doubler must be facing rib 4). to ribs and rib platforms to building board. on rib 3 then slip ribs 9 & 14 into their respective notches. has no notch at one end-this unnotched end must be at wing center as shown). Rest notched Trailing Edge (T.E.) on rib platforms (Important: the T.E. Respective places over plan (position rib 3 so ply doubler faces towards rib 4) Using no glue, place platform ribs 3,9, & 14 on spar at their To rib 3 (IMPORTANT! Position slot in ply doubler at top edge of rib 3).ĢB. Ĝhipmunk Basic is an old fashioned Basic interpreter which runs on almost all Macs, and is accelerated for PowerMacs. CAUTION: Do not build two RIGHT WINGS!Ģa. Hold spar in exact position by crosspinning at circled location on plan. ![]() Position one main spar in place over RIGHT WING (or One for the right wing and one for the left.ġ. Since the wing is built in two halves, and steps 1 to 17 are repeated in the process, two check boxes are provided with each of these steps. “Right” or “Left” wing refers to the panel being assembled during that particular step OVER THE PLANS. IMPORTANT, wing assembly will begin with building a panel overt the “RIGHT WING” on the full-size plan, later on when it is turned over, this wing will of course become the left wing. As an aid for proper rib orientation, the tip spar notches for some ribs have only been partially laser cut. IMPORTANT! Although the wing is a symmetrical section, because of internal structure (landing gear and aileron bellcrank mounts), some ribs are not symmetrical(such as Ribs No. PROCEDURE: The wing panels are assembled bottom side up and then turned over for joining and finishing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |